Collection of data on wastes with barcode scanner

During the waste collection, it is possible to enter the data on wastes in the barcode scanner by means of the Yamatec PocketOil program installed in the scanner. The operator reads the barcode from the machine lubrication point label first. On the basis of the barcode the Yamatec PocketOil program identifies the machine, the lubrication point and the waste collected at the given point. Thereafter, the operator enters the waste quantity.

To enable this operating procedure, it is necessary to print the labels with barcodes of the lubrication points first. This is secured by the Yamatec Oil program. Afterwards, these labels are attached on the machine lubrication points.

When the labels are placed on the machine, the operator can start entering data on the collected wastes. He launches the Yamatec PocketOil program in the scanner and then the module for entering data on wastes. After the waste collection is completed, he reads the barcode of the lubrication point from the machine label. The Yamatec PocketOil program in the reader identifies the machine, the lubrication point and the lubricant used at this point. Thereafter, the operator enters the collected waste quantity. He repeats this procedure with all machines determined for waste collection and enters the required data in the scanner each time.

After all collections are executed, the operator returns to the computer and connects the barcode scanner to the computer via a USB cable. Thereafter, he launches the Yamatec Oil program which loads all recorded waste data from the scanner to the computer.